International Space Station With Rocket

So in this instructible I made the ISS and also a rocket above it. I made it because I really like space.

The only website needed is https://www.tinkercad.com It is really useful for 3d printing and designing

First I made a base for the ISS. I made mine not too big, and lifted of the blue grid so I would have more room.

Next I added the main beam of the ISS on top of the base.

Next I added holders for two handel bars which are 4 it total and are oriented.

Next I added two hexagon prisms and one beam that goes through everything.

After that I added some buttons and a satellite dish to pick up signals.

Now we are going to work on the back. Here I added the main beam for the back and some hexagonal prisms along with a smaller beam inside the larger beam that is going to hold our solar panels.

here I added some buttons and details to the back beams along with the same satellite dish we used previously here.

Here are the basic back panels. They are just blue rectangles orientated.

Here are some lines to separate the panels to make them look more realistic.

Next add two thin white rectangles coming off the back

Add triangles to the white rectangles.

Here I just added some decoration

Here is a lot of steps. First add a white long rectangle shifted 45 degrees. Then at the end add a hexagonal prism. Coming off of the beam are two white rectangles that are orientated 45 degrees. Between the two rectangles is a shape made of two half ovals and two squares. this is where the grey beams will come off for our major solar panels.

After that add two grey beams (one coming of of the weird shape and another of the hexagonal prism. Underneath the blue solar panels add some orange rectangles directly under it.

Similar to the back solar panels, add lines to make them more realistic.

Copy paste the bottom panels and put them on the top

Now, copy paste that entire right section and flip it, then put it on the other side.

Now we are going to make the scope that will help us see. it consists of 5 cylinders, two for the scopes body, two for the joints, and one for the lens.

Next we are going to make a tank. It is made up of 5 cylinders, 4 for the storage, and one cross beam holding the outer two. The tank is placed under the scope and onto the base

Now lets work on the rocket. Load up a new project. You don't have to, but it will make building a whole lot easier.

Create a white cylinder slightly of the ground.

Next add a nose.

Now lets work on the rocket boosters start with a simple white cylinder.

Now add a black donut shape under it, but not touching

Add a black cylinder connecting these two shapes.

Add a white cone in-between the two black shapes. Only the edge of the cone should stick out.

Copy paste the booster twice and put them around.

For the wings, use the drawing tool to make them, and then outline them in black

For decoration, add a black beam down the middle.

Now we are going to add the piolet seat and a tip. The cockpit is a black circle inside of the cone tip we made earlier. After that add a smaller version of the white cone on top of it but black.

Copy paste the rocket to the old ISS and orientated however way you like.

And Boom. Your done.