Improve a CPU Fan

by Markus Opitz in Workshop > Tools

652 Views, 6 Favorites, 0 Comments

Improve a CPU Fan

CPU_fan_Title1.jpg

For another project, I needed a reasonably strong but quiet airflow. It should be for a wind instrument.

CPU fans are nice and quiet, but unfortunately they don't provide a directed airflow. So it's time to rebuild!

Supplies

CPU fan 12x12 cm

3D printer

drill, hot glue, (cardboard)

Disassemble CPU Fan

IMG_20231112_130640_HDR.jpg
IMG_20231112_130657_HDR.jpg
IMG_20231112_130749.jpg
IMG_20231112_130916.jpg

Underneath the sticker in the center is a retaining ring, usually made of plastic. Pull it out with fine pliers and keep it safe!

Pull off the old propeller, pinch off the blades with pliers and file away the remains.

Then you can reinsert this center part (it contains a ring magnet) and secure it with the plastic ring.

The New Parts

IMG_20231112_204643.jpg

Print out the new parts and clean them of any protruding plastic residues.

You can simply attach the new fan.

Too big/too small?

File away more or put one or more strips of paper in between.

The Air Outlet

IMG_20231112_204014.jpg
IMG_20231112_160932.jpg
IMG_20231101_140705.jpg

The new air outlet must be fitted at one corner. To do this, drill a 1 cm hole in the frame of the fan or remove the inner plastic at the corner completely.

The new outlet can then be fitted and sealed with hot glue.

Deflector

CPU_fan_blende.jpg

There is enough space between the frame and the fan blades. However, the shoveled air must be forced towards the air outlet. We therefore place a small sheet of cardboard or plastic underneath the air outlet.

Superglue or hot glue will help.

Close the Pump

IMG_20231112_210000_HDR.jpg
IMG_20231112_210158_HDR.jpg

The front and back can now be sealed either with plastic or - quicker and cheaper - with cardboard. Fix with screws, tape or hot glue to seal.


Done. Now you have a relatively strong and quiet air flow.