Illuminated Snowflake Ornament

This is my fourth and final entry for the 3D ornament contest. Similar to my ornament of culture design, this ornament will also illuminate and cast shadows in the shapes of snow flakes. This design is non-commercial share alike, however it may be used for charitable purposes. I'd recommend printing with PLA with the extruder set to 230C the print bed at 30C, extrusion speed at 80mms traveling at 155mms. You should use 3 shells, .25mm-.30mm layers, and 10%-25% infill depending on how fast you want to print it. Make sure to check out my other entries for this contest as well.

--Have A Wonderful Holiday Season--