How to Program ATtiny85 With Raspberry Pi?

A long time ago i wrote "How to program ATtiny85 with parallel port", but parallel port is OUT
So i decided to make a new tutorital!
You need:
    - Raspberry Pi(any)
    - Some jumper cables(pins to breadboard)
    - one gpio pin(optional, but it makes your life simpler)
    - Breadboard
    - ATtiny(25/45/85)
    - maybe 4 x 400 ohm resistors(to avoid errors)
I used Arch Linux on my rpi

Now do the following commands:
I MADE STUFF EASYER FOR ARCH LINUX USERS, YOU CAN USE YAOURT NOW(yaourt -S avrdude-rpi)
[mark@berryterminal ~]$ sudo pacman -S bison automake autoconf flex git gcc
[mark@berryterminal ~]$ sudo pacman -S avr-binutils avr-gcc avr-libc
and clone custom avrdude from https://github.com/kcuzner/avrdude
[mark@berryterminal ~]$ git clone https://github.com/kcuzner/avrdude
[mark@berryterminal ~/avrdude]$ ./bootstrap && ./configure && sudo make install


Now download Makefile from here: http://db.tt/W0MyDOXn
and now connect cables to breadboard. I use this pinout: http://elinux.org/File:GPIOs.png(yeah, 1-26)
Try to probe attiny85:
sudo avrdude -p t85 -P /dev/spidev0.0 -c linuxspi -b 10000
If it works then you're done! Happy programming =)