How to No Clean Solder Bullet Connectors With Torch
by chrisayad in Circuits > Soldering
1351 Views, 11 Favorites, 0 Comments
How to No Clean Solder Bullet Connectors With Torch
![bulletimg.PNG](/proxy/?url=https://content.instructables.com/FOT/JLWL/HMVJHLUB/FOTJLWLHMVJHLUB.png&filename=bulletimg.PNG)
https://www.youtube.com/watch?v=-4foev6hjJk&list=UUtdaP5PA2pnusjzVEG8gP9Q
1.Heat up the clamp a little bit and the bullet and then hold it on the end for a couple of seconds. If it gets red, its too hot.
2.Put some silver solder with flux core in there until it holds about 3/4 full of solder, try to stir it so there are no air bubbles.
3.Give it another shot of heat and gently place the wire inside and swirl a little bit, add heat if necessary. (watch out for the plastic.)
4. Take a deep breath of solder fumes and then blow on it.
1.Heat up the clamp a little bit and the bullet and then hold it on the end for a couple of seconds. If it gets red, its too hot.
2.Put some silver solder with flux core in there until it holds about 3/4 full of solder, try to stir it so there are no air bubbles.
3.Give it another shot of heat and gently place the wire inside and swirl a little bit, add heat if necessary. (watch out for the plastic.)
4. Take a deep breath of solder fumes and then blow on it.