How to Make a Little Fence
by Andruha1123 in Workshop > Home Improvement
11010 Views, 40 Favorites, 0 Comments
How to Make a Little Fence
ok, have you been remodeling your house and have some hardwood floor board left? Well we did, most of them are rejects, some were just left over. So, me and my dad made this little fence around shed in our backyard. It took about 2-3 hours.
Tools
Ok, you will need some tools.
1 pic: table saw
2 pic: compresor
3 pic: Compound Miter Saw
1 pic: table saw
2 pic: compresor
3 pic: Compound Miter Saw
Preparation
Get some boards. I used left over hardwood floor boards.
Cut them to desired height and width.
Make a pointy thing on the top.
Then make a frame, you can use any long boards, i used 1x2 boards.(i think). I used 2x4s for the ones that went into the ground.
Cut them to desired height and width.
Make a pointy thing on the top.
Then make a frame, you can use any long boards, i used 1x2 boards.(i think). I used 2x4s for the ones that went into the ground.
Nail the Boards
Use a nail gun and nail those small boards to the frame.
But first, nail two boards at each side of a fence and nail a long board to the top, make sure it is leveled.This will make it easier to make them look all even. Leave an inch between them.
But first, nail two boards at each side of a fence and nail a long board to the top, make sure it is leveled.This will make it easier to make them look all even. Leave an inch between them.
YOU ARE DONE!!!
You're done.
you can paint it, or leave it like that, you choice .
Leave some comment, don't be too cruel this is my first instructable.
you can paint it, or leave it like that, you choice .
Leave some comment, don't be too cruel this is my first instructable.