How to Make a Duct Tape Id Card Holder

This is how to make an id card holder.

since im going into high school i need my id wherever i go so i made this.

I put this card holder in my student handbook (assesment notebook) because i take that to all my classes.

And yes i turned my id card around to protect my identity!

1.duct tape
2.scissors
3.whatever you are going to put your id (notebooks etc.

First you need to rip of a piece of duct tape and measure it next to your id card and stick it on.

now you rip off another piece of duct tape the same size as the other one and stick it on.

now put your card on them and see if it is to your liking.

now rip off a piece of duct tape and measure it on your card.

Then once you do that rip off a big piece of duct tape. Now take your piece you riped of earlier and put that in the middle. (if you need help refer to picture #2)

Now put your card on the card holder and now take your piece of duct tape you just made and stick it on.

The non sticky side goes on your card and the sticky part goes on the sides.

Now measure another piece of duct next to the one u just put on and stick that piece on the bottom (refer to the picture below) this piece of duct tape will make your card not fall out.


There you go! You now have your very own duct tape card id card holder!