How to Make Hand Made PCB
by chetanrobozz in Circuits > Soldering
5986 Views, 41 Favorites, 0 Comments
How to Make Hand Made PCB
.jpg)
Robozz Lab
Today We are going to teach you how to make a hand made pcb(printed circuit board).
Step one : Firstly cut that pcb as par your pcb layout size.
we made the pcb circuit schematic and layout using EAGLE Software
Carbon Stuck With Copper Plate
.jpg)
Clean the Pcb Plate With the Help of Sand Paper
.jpg)
Put It on Your Printed Design
.jpg)
you can use magzine paper for design printing
or you can use glossy paper.
Cover It From All Side
.jpg)
Iron It for Just Few Minutes Until Tracks on That Pcb Wont Shown.
.jpg)
.jpg)
Put the Water in a Box
.jpg)
Put That Pcb on the Water Box.
.jpg)
Erase That Magzine Paper Very Preciously.
.jpg)
Here Is Your Printed Design.
.jpg)
Now Check Every Track If They Are Joined With Another Track Remove It.
.jpg)
Put Some Boiled Water and Some Fecl3 Powder on That Box and Put That Pcb and Shake It Slowly.
.jpg)
Copper Will Be Erased in Few Minutes and You Will Get Only Your Tracks.
.jpg)
Now Again Rough It With Sand Paper.
.jpg)
Make Drill With the Help of Drill Machine and Insert Component and Solder Them.
.jpg)
And You'll Get Your Final Pcb
.jpg)
Contact Us: CORPORATE (INDORE )
ROBOZZ LAB, 2nd FLOOR , SUNDERAM COMPLEX, BHAWARKUA INDORE- 452001
Mob.: +91-8253-011-002 , +91-7806-093-134
Mail Us: robozzlab@gmail.com
Visit us on : www.robozzlab.com www.robozzlab.com
https://www.youtube.com/robozzlab
https://in.linkedin.com/in/robozzlab