How to Put a Logo on Knife Blade : Laser Engraving

The point of this project is to engrave a logo on a knife blade.

So you'll need :

- A knife

- A logo

- A laser cutter/engraver ( Here it's a TROTEC SPEEDY 300, 60W )

- A can of THERMARK or CerMark Spray

It has to be down to its final finish, otherwise you'll peel off the logo.

You don't want the thermark spray to cover the wood of your handle ( maybe you could wipe it off easily, but i don't wish to try.)

You may use acetone (please wear gas mask and gloves)

Not too thick.

The can needs a few minutes of shaking before use

I was extra cautious making the blade horizontal in X and Y directions in the laser cutter.

Then fired it at 1000DPI (metal has extremely high engraving fidelity) and using the metal preset in JobControl

This is it !