How to Make an R2 Droid in TinkerCAD
by Micalpickle7 in Workshop > 3D Printing
865 Views, 3 Favorites, 0 Comments
How to Make an R2 Droid in TinkerCAD

This project will show you how to make an R2 droid from Star Wars. please note that this is not very detailed, this is more of the basic shape that you can build off of.
To Start


to start, open up a new project and pull out a cylinder.
Size It Up...


size the cylinder to be at your prefered height, (I did 102) and make it 120x120.
The Top


now take a half sphere and make it the same dimensions in length as your body, (120x120) it's height should be at 46.
The Side Legs


now take a round roof, and make it at a height of 117. make sure that it hangs of the side off your droid. do the same for the next side.
The Middle Leg



now make a scribble like the one that I created. once you did that center it in the middle of the base but make sur it sticks out a bit. now take a cylinder to connect it to the body.
Extras



now that the body is done you can put on the rest of the pieces like I did with the eye. I didn't do more than that, but be creative, tinker around.