How to Make a Round Yo-yo
How to make a round yo-yo and by the way I have not tested it myself so if you do make it Can you tell me is it works this is my first instructable this yo yo is based off of the square yo yo that was made by https://www.instructables.com/member/lrigoulot/
and here it’s the link to his yo yo
https://www.instructables.com/Designing-and-Building-a-Square-Yo-Yo-Using-Tinker/
Supplies
im using Tinkercad on a iPad if possible works better on a computer you are going to need three orange cylinders and a clear cylinder
Ok first you are going to click on the cylinder and a grey square is going to pop up and to adjust length,width, and height the first orange cylinder for the height you are going to make it 10.00,width 50 , and length 50.
Ok now you are going to take the 2nd cylinder and you are going to make it 10.0 wide,10.0 length ,and height is going to be 5
You are going to repeat the first step
Ok so now you are going list the first block up and then place the the second cylinder on the first cylinder
Take the second cylinder and place it on top of the other cylinder
[optional] Now you are going to get a half sphere from the selection of shapes and place it on the top of the top cylinder the dimensions for the half sphere Is height 5 width50 and length50
[optional] repeat step 6 half sphere dimensions height 5 width 50 length 50
[optional]rings go to your shapes and go to the bottom and you will see a ring looking shape you are going to take that and make a halo dimensions is height 2 width51 length 51 (do this to both side top and bottom if wanted)
Now at the biggining you should have gotten a clear cylinder take it and turn it side ways the the dimensions are height 20 width 2 and length 2 and put it in the middle cylinder
