How to Make a Paracord Watch With Buckle

Throughout this Instructable I will show you how to make a paracord watch. Some people call them survival watches, ICE watches or tactical watches, whatever you call it, they are great items to have with you when exploring the outdoors.

If you enjoy my Instructables, perhaps browsing my personal online shop which offers beautiful handcrafted watches that are made out of wood, and other unique handcrafted wooden gifts.

Here's what you'll need:

• Lighter
• Watch Face
• Plastic Side Release Buckle. I get mine from Amazon Here
• Tape Measure or Ruler
• 12 Feet of 550 Paracord. You can also can get cord on Amazon Here. Or you can find Genuine Mil-c-5040h Type III 550 Cord on my personal website Here
• Scissors

1. Wrap a string, cord, or small rope around your wrist. Make sure it is very snug. Not overly tight, but do not make it loose.
2. Take a marker and draw a line across the two crossing cords/strings.
3. I've darkened my lines in photoshop to demonstrate what it should look like in this step.
4. Now measure from the first line to the second line.

First things first you're going to take your 12 feet of 550 Paracord and cut it directly in half so you have two 6 foot lengths of cord.

Take the two 6 foot lengths and fold them both in half. At the half-way point tie a cow-hitch knot onto the buckles.

Here's a quick and easy tutorial on how to tie a cow hitch: How to tie a cow hitch

Take both buckles with respected paracord and feed the cord down through the pins on the watch face.

Make sure your buckles are setup the proper way. They should be arching downwards to fit your wrist properly. If they are upside down it won't work properly.

Now you're going to take your loose ends (working ends) of the paracord and feed them back through the buckle on either side.

Make sure to keep the cord on the outside of the cow hitch like shown in Diagram 1.

Now continue the cords back through the watch face on both sides. Remember to come from top to bottom through the pin, and on the outside of the cord that is already fead through the watch like shown in Diagram 1.

The numbers below match with the numbers in the photo.

1. Take the left cord and carry it under the band to the right side.
2. Now take your right cord and bring it underneath the cord you just brought over from the left.
3. Continue with the same cord from step 3 and carry it over the band and up through the loop you created on the left side.
4. When tightened it should look like this.

The numbers below match with the numbers in the photo.

This step is the same as before, just opposite.

1. Take the right cord and carry it under the band to the left side.
2. Now take your left cord and bring it underneath the cord you just brought over from the right.
3. Continue with the same cord from step 3 and carry it over the band and up through the loop you created on the right side.

Your watch should now look like the photo in this step.

Now you are going to repeat Steps 7 and 8 so you have what you see here in step 10.

1. Cut the ends close to the braids. Not too close you don't want it to pull through.
2. Using your lighter, hold the flame on the frilled ends for about 3-5 seconds or until it's nice and molted. Then lick your finger and smush it down so it melts into the braids.
3. Here's what it should look like.

Check out my personal website for more tutorials and genuine mil-c-5040h Type III 550 Paracord here: ParaVival