How to Make a DIY 40 Caliber Bullet Casing Paracord Bracelet
by OzonerPlays in Craft > Jewelry
26 Views, 0 Favorites, 0 Comments
How to Make a DIY 40 Caliber Bullet Casing Paracord Bracelet
.jpg)
Hey Guys!
Did you ever think of making your own Para cord bracelet in easy steps.
The things that you are going to need are:
two 40 caliber bullet casings
a scissor
a para cord
a 40 inch salt copper wire
and last but not the least a glue gun
You can get the bullet casings from here
How to Make a DIY 40 Caliber Bullet Casing Paracord Bracelet Method
Add a tiny bit of glue with the glue gun in one of the bullet casing.Now get your para cord and the salt copper wire together and put them inside the bullet casing together.Now you let the glue get attached to the para cord and the salt copper wire for a little bit of time.While it is doing its job here are a few tips.
1 : Wearing the bracelet with the bullet casings up look more attractive than wearing it with the bullet casings down.
2 : Make sure that the bullet casing has a white hole in the center this means that it is not an gunpowder (explosive) bullet.
When your glue has stick to the para cord and the salt copper wire,now is the easy part.What you need to do is just roll the para cord around the salt copper wire until it is done.Make sure you first flatten the salt copper wire for easier use.When only like a cm is left glue the remaining salt copper wire and continue your rolling.When the glue has dried cut the remaining para cord.Now the last step is to add a little bit of glue in the second bullet casing and put your salt copper wire covered by a para cord inside it.Let it stick and it is done!