How to Make a Cubes and Pegs Puzzle Out of Scrap Recycled Wood

A new day, a new puzzle. This is another puzzle I made out of some material i had laying around. Its a different design than the burr and rope cube puzzle designs. I actually found this one online and thought it would be relatively easy to make until i figure out how to rig up a set up for making true burr puzzles.

Saw and Drill

3/8 Drill Bit

Rubber mallet (optional)

3/8 Dowel 1 and a half foot long

3.5 X 3.5 X 3.5 Wooden Block

Sandpaper

There are eight pieces total. Each piece is a 1.5 cube with a total of three holes cut into each. Four of the pieces have two pegs put into them with one hole, the other four have one peg and two holes. Each peg is 1.25. The holes cut are .5 by .5 from the side (the paper square is .5 by .5 and the corner is where the cut is marked.)

The design i made is a little bit different than the original puzzle as you can see. I posted the pictures in a format where each peg is pointed directly at the hole it corresponds too so you will be able to see how it is made and solved. Hope you enjoy making and doing these puzzles! c=