How to Make a Cs:go Style Knife With a Paracord and Butter Knife

Today I am going to show you how to make a knife with simple house and garage supplies in the style of a cs:go skin. This is super simple and as long a you follow this tutorial you could probably finish this in a hour or two.

• Paracords
• Lighter
• A rotary carver (If you want to make a design the blade)
• A butter knife
• Ruler
• Pencil/marker
• Scissor

Bare with me this step is quite easy as you only need a paracord and some listening skills to create a functioning paracord knot. First spread out your paracord so it's a straight line. When you then get a Ruler please measure out a 20 cm length from the end to the 20 cm. Then cut the 20 cm with your scissor. If you are still a measly child please ask a guardian or parent to do these next steps. Take a lighter and cut the ends of the paracord you cut out. This will harden the end and give it a plastic feel. Then follow the steps on the pictures below. After this tighten the ends with a lot of strength again so it wont fall off.

Images from Swiss Paracord GmbH. „Paracord Knots“. Swiss Paracord GmbH, 7. September 2016, blog.swiss-paracord.ch/portfolio-item/paracord-knots.

Sharpening the blade is a quiet simple step as there are only a couple tools needed for this, there is not a lot that can go wrong with this step as long as you follow the steps. First clean the blade itself and then clean the work station with wet wipes and cleaning alcohol. Then start the sharpen the knife with swift but heavy swipes from the sharpener, but make sure to swipe it away from your body.

This step is actually quite simple as there are no other tools needed other than a pencil, paper a phone to view similar designs and a rotary carver. First open  up your phone and type in your internet searcher “Repeatable design wallpapers”. Now select a couple of photos you enjoy. Take your pencil and paper and sketch some similar designs of the wallpapers saved on your phone. After you are done make sure that this is the correct design you want to create. Take a pencil or a marker, it does not really matter just make sure you are able to see the sketches on the bladee when you actually draw on it. Then take your design you previously created and draw something similar on the bladee, you can always scrub it as it is only on metal and with water it would scrub away. Repeat this process until you are happy with your design on the bladee. Now turn on your rotary carver be careful not to cut or damage your soft skin or surface you are cutting it on. And don't forget that your finger is more important than a beautiful knife. Also please make sure to not press down to hard as not to damage the stability of the blade it self.