How to Make a 3D Fusible/perler Bead Pumpkin
by TheWinner123 in Craft > Art
465 Views, 6 Favorites, 0 Comments
How to Make a 3D Fusible/perler Bead Pumpkin
This is a Perler bead pumpkin! Its super fun to make And looks great as a Halloween decoration
Supplies
Orange, black, brown perler beads, board, iron, parchment paper
The Layout
Make these shapes with your beads on the board then lay the parchment paper on top of it. Next firmly heat up the beads by laying the iron on the parchment paper.
Put Together
After ironing it, get these 3 shapes and lay them like this
Put the side pieces on to the middle piece (see above)
Then get this new piece and attach it onto the bottom
It should look like this
Then get this new piece and attach it onto the back
Then put this piece on the top
After that get these pieces and separate the one that has black on it and the one with a hole from the others
Then put the piece that has black on it on the front of the pumpkin (see above)
Then get the piece that has a hole in it and put it on the top of the pumpkin
Then attach all of the other ones to the sides and to the bottom.
Next get the stem and put it in the top hole about 1 bead deep.
You're done! It should look like this