How to Make Simple Electric Elevator Model From Cardboard. Model for Science Project

In this project, I wanted to make an electric elevator model for your science projects using simple recycled materials and cardboard.

• 5mm foamcore or Cardboard

• 250RPM DC 6V Motor

• 2mm Galvanized Steel Wire

• 3mm Ferrule Terminal

• Plastic Pulley harvested from Old DVD burner

• AAA Battery & Battery Holder

• AWG24 Wire harvested from old electronics

• ON/OFF/ON Slide Switch harvested from old electronics

• Optional for Cabin Light

• 5mm LED
• CR2032 Battery
• On/Off Slide Switch harvested from old electronics

• Nylon thread

Print below PDF file on A4 Paper (or Sticker) for proper cut.

Model Plan Link Alternative

Stick plans onto 5mm thick foam core or Cardboard.

Cut all the pieces from the marked lines with a utility knife.

Glue the support pieces to the facade.

Cut 2mm Galvanized Steel Wire, streighten with electric screwdriver.

Cut 26cm 2pcs straight wire for cabin travel guide.

Glue Facade Piece onto Base.

Drill holes for wire guide

Stick top piece onto facade piece

Heat up cable ferrule with lighter and remove the plastic part.

Glue the 26cm long straight wires by attaching the bushing pieces between the upper and lower parts.

Glue the cabinet between the Bushing pieces.

Test that the cabinet moves freely on the rod guide with bushing parts.

Mount pulley on 250rpm motor shaft.

Cut off the bottom of the syringe plunger and make a hole in it. Stick it on the cabin for cabin engine connection.

Tie a rope to the Cabin Rope Bracket.

Mount the DC motor at the top of the structure and glue the cabin rope to the plastic pulley attached to the motor shaft.

Solder the cables to the slide switch in accordance with the schematic diagram.

Don't forget the passenger

Enjoy!

Thanks in advance for your kind comments. ✌