How to Make Ring Toss in Tinkercad

Welcome to this project! We will be making ring toss in Tinkercad!

To start, get a box and adjust the size to 159.00 width by pressing the corner and going out.

Then, get a cylinder, put it anywhere and make it 1.00 high and 4.00 width.

After that, copy them by touching the cylinder, pressing Ctrl c and then ctrl v 2 times. Then place the 2 more sticks.

TIP: avoid placing the sticks in the same spot.

Before we finish, grab 3 rings and place them on the workplace, NOT ON THE BASE

Grab a text box, title it ring toss, make it as small as you want, then move your camera to the side, adjust the side side to -82, put it on the base, and slide it in where you want it.

Finally, group the box, cylinders, and text. DO NOT GROUP THE RINGS!!

CONGRATULATIONS!!! You have successfully completed the Ring Toss. All you have to do is print it!