How to Make Led Brightness Controller

by ykelectrical3 in Circuits > Soldering

321 Views, 0 Favorites, 0 Comments

How to Make Led Brightness Controller

Snapshot_376.PNG
Snapshot_376.PNG

The LED Brightness Control System is a comprehensive project aimed at optimizing energy consumption and enhancing lighting efficiency in a large-scale setting. With the increasing demand for energy-efficient solutions, especially in urban areas, this project addresses the need for smarter lighting management systems. By employing advanced technology and innovative control mechanisms, this system aims to regulate the brightness of LED lights efficiently.

                   

Things used in this project-:

1. Hardware Components-

  1. Jumper Wire 
  2. 5mm LED 
  3. Volt Meter
  4. Breadboard
  5. Potentiometer
  6. Heat sink
  7. lm317 voltage regulator
  8. 12 Volt Connector
  9. Zero PCB Board
  10. Banana connector

2. Hand tools and fabrication machine-

  1. Soldering iron (generic)
  2. Solder Wire, Lead-Free
  3. Solder Flux, Soldering


Story-

                

The LED brightness control system utilizes a potentiometer to regulate light intensity effortlessly. With a simple twist, users can fine-tune the brightness of LED lights to suit their preferences, creating a customized lighting environment. The potentiometer acts as a variable resistor, adjusting the voltage supplied to the LEDs and consequently altering their brightness levels. This intuitive control mechanism offers convenience and flexibility, allowing for seamless adjustments without the need for complex interfaces or programming. Whether for ambiance creation or energy efficiency, the potentiometer-based LED brightness control system puts illumination control directly at users' fingertips.


CKT Diagram -







                                                    

                                                     ( Reference CKT )



Before we can get started, first of all, we have to design the circuit, after creating the circuit, and then we have to design the PCB. As you can see here, I have designed a PCB for an LED brightness control circuit using zero PCB.



 Components Required-

To build this LED brightness control device, you will need the following components

  • Jumper Wire 
  • 5mm LED 
  • Volt Meter
  • Breadboard
  • Potentiometer
  • Heat sink
  • lm317 voltage regulator 
  • 12 Volt Connector
  • Zero PCB Board
  • Banana connector


You can purchase all these components from “ Winsource Electronics” 


Snapshot_377.PNG
Snapshot_378.PNG

Fits of all we have to make the ckt on zero pcb so i have cut a piece and after that i will put all the components into it

Snapshot_379.PNG
Snapshot_380.PNG

Now after putting all the components lets solder all the components