How to Make Cardboard Gun USP Pistol That Shoots Rubber Bullets DIY at Home
5940 Views, 2 Favorites, 0 Comments
How to Make Cardboard Gun USP Pistol That Shoots Rubber Bullets DIY at Home
Materials you will need-
-Cardboard
-Pen knife
-Foldable cardboard
-Push to on switch
-Rubber piston syringe
-Flow pipe
-Air pump motor
-Battery
-Wooden sticks
-Super glue
-Paper strips of width 1cm
Using the Pen Knife, Make the Following Cardboard Cutout As Shown. Separate the Upper Layer of the Cardboard.
Stick Cardboard Pieces As Shown in the Following Images.
Place the Push to on Switch As Shown.
Take the Rubber Out of the Syringe. Attach a Flow Pipe to the Tip of the Syringe As Shown.
Take Foldable Cardboard Pieces of 10.5cm Width and Roll Them Over the Syringe As Shown. Now, Take a Small Piece of Foldable Cardboard and Roll It Over the Top As Shown.
Attach the Other End of the Flow Pipe to the Air Pump Motor As Shown. Place the Battery As Shown.
Make the Connections As Shown in the Following Image. Cover the Other End of the Pistol.
Make a Slot to Change the Battery As Shown. Insert Wooden Sticks in the Slot, Cut the Extra Portion of the Stick, and Apply Super Glue.
To Make the Bullets, Roll the Paper Strip Over a Piece of Wooden Stick, Cut Out the Extra Portion and Apply Super Glue. Insert It Into the Rubber of the Syringe As Shown.
Insert the Bullet Into the Top of the Pistol. Your Pistol Is Ready to Fire!
