How to Change the Mode on Your Phantom 1 Transmitter

by DefeatedWarrior in Circuits > Remote Control

322 Views, 2 Favorites, 0 Comments

How to Change the Mode on Your Phantom 1 Transmitter

GOPR0098.JPG

Does your phantom 1 use the wrong mode? Well this instructable will show you how to change it in the hardware.

Supplies

GOPR0099.JPG
GOPR0100.JPG

All you need is a Phantom 1 TX

Open It Up

GOPR0100.JPG

Take out these 4 screws. BE WARNED, the back shell is attached near the antenna, if you pull up to hard it will break.

Swapping the Wires

GOPR0106.png

All you need to do is swap the two sets of wires.

Last step is to put the case back together. Make sure you put the top in first.