How to Build a PowerTech Miniature (dragon Bus)

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

|________|________|________|________|________|__________|________|_______|__________|_______|______|

1. 4 Wheels
2. a battery pack
3. 3 batteries
4. 4 wires (2 red 2 black) (two already connected to the battery pack)
5. 4 cranks (wheel connector)
6. 4 metal rods(big)
7. 2 metal rods(small)
8. 2 motors
9. 6 gears
10. 1 plastic shell
11. 4 metal nuts
12. 4 plastic nuts
13. 2 left halves of motos casing
14. 2 right halves of motos casing
15. 3 short rubber tubes
16. 5 long rubber tubes
17. 11 medium screws (flat tip)
18. 5 long screws (flat tip)
19. 6 short screws (pointy tip)

.Tools.

([{Screwdriver)]}

repeat these steps twice because there are two motors

Gather The Materials:

6 Total gears (2 small) (2 double sided) (2 normal)

4 Total long metal rods

2 Total short metal rods

6 Total small screws

Materials for one motor

3 Gears (1 small) (1 Double sided) (1 normal)

2 Long metal rods

1 Short metal rod

3 Small screws

slide two the long metal rods into the lower half of the half of the motors shell. Then insert the small metal rod into the upper half of the half of the motor shell. Now insert the red gears one at a time like the picture shows. repeat for other motor.

Now insert the motor so the white rod on the motor touches the top red gear.

Now slide the other half of the motor shell over all of the metal rods so it looks similar to the first image then use the small pointy tip screws and screw them in to hold the two halves of the motor together so that it looks similar to the second image but instead the screws are screwed in.

1. grab your long baseboard and attach the motors so one of them is upside down and the other right side up

Use tape for the battery pack and little screws and plastic nuts.

to attach the wheels attach them to the crank using screws plastic covers and plastic nuts.

Here is the link to a video of more or less the same miniatures HERE

measurements for all the parts

Wheels : diameter 8cm circumference 25.1327412287185cm

Frame length 13cm width 5cm