How to Make an Easy PCB Drill Using RC Car...!!!

How To Make An Easy PCB Drill Using  RC Toy Car and it is working
on (PCB,thin Plastic,Thin Wood,and any Thin Things ,etc..)
and its Awesome..!!! and Soooooo easy to made.
 

You Will Need:

- An Old RC Car
- Wires
-DC Power Jack 
-switch
- 6 Volt  Transformer or 6 Volt Battery
- Thin Drill Bit or You Can Make Your Own
- Pen Tube
- Case For Your Drill You Can Use PVC As Case To Make it Look Like Dremel you can use a plastic egg like me

Tools:

-Cutter or Scissors or X-acto Knife
-Phillips Screwdriver
-Solder Iron
-Solder

we will get the motor from the RC car's gear box ,take the motor out from the gearbox using the screwdriver and remove the motor's gear.

connect the switch to the motor then connect the switch to the motor like shown in the picture using solder iron .

first  make sure that the motor is the same size of the plastic egg then make holes in the egg for the wires and the motor's shift then  insert the wires and the motor's shift inside the plastic egg and close it and make secure it .

just add your drill bit and make it secure with the plastic pin's tube and you are done and you can test it .