How I Made a Plant Swing Holder

Paul Fleck

4 pieces of 60 inch rope

1 primed finger joint board 1/8/8

4 all purpose hook

Measure the size of your window frame. Mine was 14in by 7in by 60in.

Measure your window from top to bottom. My window was 60in long, so I cut 4 pieces of rope 60in long.

I made the board a little smaller than the length of the window frame, so I can fit part of it into the frame. So I made my board 13.5in.

Make a hole in each corner of the boards. I clamped all of the boards together so then I only needed to make four holes through the boards.

Put the ropes through all the holes in the three boards. When done putting a rope through a hole, tie a not under the board. This second part is optional because its just for design: when done putting all of the ropes through the holes and tying them, then loop the board through it's rope to get a twisted design.

Put the hooks on the top of your window frame. This will hold up the boards and rope.

Now just tie the top ropes to the hooks and then put plants on it or what ever you want.