Hot Glue Magnet

This is a super simple way to make a a customized magnet using hot glue :D

-Graphics (Magazine, Comic Book, Prints, etc)

-Scissors

-Hot glue

-Mold (here I'm using a bottle cap)

-Magnet strip

The title says it all :D Simply trace the bottle cap onto the graphic of your choosing.

Once you're done tracing, simply cut it with scissors.

Put the graphic into the cap, faced down. The blank side/ the side you don't want should be facing you.

Fill the cap with hot glue and let it dries.

Pipe some more hot glue onto the middle in order to stick the magnet on.

This part is a little tricky, I used a utility knife to peel it out, but you can use anything that has a sharp edge but flat surface such as a knife.

*When I was able to remove the hot glue, the graphic was a little distorted at the edge from the constant poking of the utility knife, so I cutaround the edge and made it into a smaller circle with the scissors. This is pretty easy since hot glue is relatively soft to cut into.