Homemade RC Car..!

Hello guys !

In this instructable I'm gonna show you how I made RC car from scratch ........but you can use your own parts around you...!!!

In the above pic you can see that for building chassis I have used casio calculator frame...

and I have used the old RC car parts i.e wheels and rear gear box mechanism.....

I have added suspension system for the car....!

I have used pen refill,thread,gear box to steer the car....

you can see how steering system is working in video which I have embed in this instructable.......!

I have designed the body using two materials....they are

1. transparent plastic bottle (which is used for making the car front glass......!)

2. plastic sheet (which is used to design the other body......!)

I have not connected RC circuit and antenna yet..........!

so in the next step I'll do that......!

I already have the rc circuit (receiver and transmitter) and which can be seen in the 1st pic..!!! and I have used male header pins to the rc receiver circuit so that I can remove circuit from the rc car and can do other projects based on rc...!!!

I have attached that RC circuit at the back end of the car and I have covered it by using a plastic sheet.......!

And I have used a old antenna which I got it from the old walkie talkie toy ..........

And to power up this RC car we just need 4 charging cells........and we can insert it just by lifting the top of the car which can be seen in third pic above............!

Ok guys to check out its performance and how its steering system works.........you must check out this video..and its only 2:15 min.....!

and I have to say one thing this car has a good steering system than other RC cars..

I hope you enjoyed it and learned something new........
................................. thank you......................................... If u have any suggestions or comments regarding to this topic plz leave a comment below..... :-)