Homemade Height and Distance Adjustable Helping Hands + Other Features.

Hi, this is a very cheap Helping Hand made from junk particles of house. It would hardly cost $1.5 to make this. In this helping hand you can adjust the height and distance between 2 hands. A box is also present to keep items such as L.E.D., motor, resistor,etc. A stand is also present for keeping the soldering iron. A free space is provided to carry out the work.

Materials Required.

Graph Paper
Roller Skates Wrench
Super Glue
Plywood Piece
Designer Cello tape
Paper Knife
Soap Cover
Alligator Clips
Epoxy Glue
Metal Pieces
Ball Bearing

Designing the Plywood.

Cut out the graph papers from their outline.
apply normal glue and paste it on the plywood.
Using the designer cello tape put the border.

Making the Helping Hands.

Take the pen knife and remove it`s bottom part.
Now remove the handle if there is any.
Don`t throw them away.
Mix the epoxy glue thoroughly.
Place a small amount of it inside the ball bearing.
Place the bottom part of the pen knife inside.
Properly fix the pen knife and leave it dry.
In the movable helping hand joint the bottom part of pen knife that you have removed and the handle of pen as shown in the photo by Superglue.
Eject little part of blade from top.
With help of epoxy glue fix them properly.

Assembling the Parts.

Attach the fixed helping hand to board by epoxy glue.
Place the movable one in front of the other and from 2 sides draw to straight lines.
On the straight line join the 2 metal strips by epoxy glue.
Behind the 2 metal strips join the roller skate wrench by epoxy glue.
At one corner join the the soap cover.
Allow it to dry completely and then it is ready.
You can also add a nail near it to keep the soldering wire.