HomeMade Modern DIY Concrete Pendant Lamp

Designer lighting can be quite pricey. You can make yourself an entire set of stylish concrete pendant lights with a single bag of concrete mix and some old plastic bottles.

Quikrete 5000 Concrete Mix
Purchase at Home Depot
QUIKRETE® 5000 Concrete Mix is a commercial-grade blend of stone or gravel, sand and cement that's specially designed for strength. It is available at Home Depot and typically comes in 80lb. bags. The hardest part about working with it is moving the 80lb. bag. Mixing the small quantity needed for this project is easy – all you have to do is add water and stir thoroughly.

Electrical Stuff: Socket, Switch and Cord
Purchase Online at Grandbrass.com

Plastic Bottle
Reclaimed + Recycled
2-liter soda bottles and a thin water bottle work well.

Threaded Tube + Nuts
Purchase Online at Grandbrass.com
These threaded tubes are a common lamp part and can be purchased online or salvaged from an old lamp. I used a 3/8th inch diameter tube.

3 1/2" Deck Screw
I used a single deck screw to help hold the plastic bottles in place.

Box Cutter or Knife

RYOBI 18 Volt Cordless Drill with a 3/8th Diameter Standard Bit
For drilling holes in the caps.

Wire Cutters
To cut the cord and strip the wires for reconnecting the socket to the cord after putting the socket inside the lamp.

Poke a hole in the soda bottle with a box cutter and use scissors to cut the bottom of the bottle.

It's easier to drill a hole in the bottle caps when they are attached to the bottle. The hole should be just big enough to screw the metal tube through.

Screw the tube through both caps and use nuts on either side of each cap to hold them in place.

Screw bottles into the connected caps.

Use a large spoon to fill the mold. Shake and tap the mold after each spoonful to make sure the concrete settles.

I used a box cutter and scissors to remove the plastic bottle.

Optional Step: Cut back metal tube 
I like the industrial look of the exposed metal, but you can cut off the excess metal with a hacksaw if you want.

I used 120 grit sandpaper to smooth down the rough edges.

Cut the socket end of the wire and thread the cut end though the bolt hole. Strip the wires and twist them together. Cover the exposed metal with electrical tape or wire nuts and make sure the pendant is securely fastened.

Good luck making your own concrete pendant lamp, and please email or tweet photos to @benuyeda or ben@homemade-modern.com. For more detailed instructions, dimensioned drawings and different variations of the project, check out our soon-to-be-released book.