Hobbit Christmas Sign

On the sixth day of Christmas my true love gave to me - a Hobbit welcome sign! Or unwelcome sign, depending on the kind of business your bringing. But remember:

Christmas business only!

Here's how I put this project together:

Materials I used: (with affiliate links)

1/2" 6"x24" pine board

Vinyl - https://amzn.to/2rwGlje

Transfer paper - https://amzn.to/2Ed37iQ

Chalk paint - https://amzn.to/36Fdw31

Nails - https://amzn.to/2PCU0x7

Craft wire - https://amzn.to/2EebpH6

Small screws

Danish oil - https://amzn.to/2YPhmUf

Tools I used:

Brother plotter - https://amzn.to/36qkFnm

Weeding hook - https://amzn.to/38AGORM

Hammer - https://amzn.to/2PDUsLA

Squeegee - https://amzn.to/2YIvvTb

Sponge

The first thing I needed to do was to go and find a font that fit the sign from the Hobbit. I found one called 'hobbiton' and downloaded and installed it. The font doesn't exactly match the sign from the Hobbit, but it was close enough.

I measured my board, and matched the dimensions in Illustrator, then type out my Hobbit message (adding in Christmas). Sizing it to the size I wanted, I centered it on the board and sent the file to my plotter.

Using the plotter software, I adjusted the message to fit corner to corner on the vinyl so ensure it was big enough for the board. I then cut it out on the plotter.

Using a weeding hook I removed all the lettering, then placed the transfer paper over the vinyl. After squeegeeing (that a word, right?) the transfer paper down I cut around the lettering.

I peeled the stencil off the backing and placed it on the board. I squeegeed the stencil evenly across the board, then removed the transfer paper.

Cutting up a small piece of sponge, I used it to dab the chalk paint onto the stencil. I let it dry, then applied another layer of paint, trying to get as even of coverage as possible.

While the paint was ever-so-slightly still wet, I started peeling the vinyl off the board (I did this to ensure that any dry paint wouldn't peel off with the stencil). I used the weeding hook to help get the smaller pieces of vinyl

Based on my stencil, I realized that I needed to cut my sign down a few inches to match the reference sign from the Hobbit. I made a mark on the sign, squared a line, then cut to size.

I took some nails that I had and cut them to size. Making 4 marks on the board that matched the placement of the nails from the sign in the Hobbit, I hammered the nails the nails into place.

Using another piece of sponge, I took some danish oil and oiled down the entire sign. I screwed 2 small screws into the back of the sign, then wrapped some craft wire around each to make it hang-able.

I wanted to mount this sign on the Candy Cane post I made, so I 3D printed a mounting hook (the same one I used to mount in the Excitebike bike shed)

Using 1 1/2" screws, I mounted the hook to the front of the candy cane post, then hung the sign

Now that the sign was proudly hung, I could welcome guests in geeky style. Or unwelcome them. It would depend on the type of business. But please, just remember:

Christmas business only!