Hexagon Snowflake Ornament

This snowflake ornament is simply but yet so pretty for a tree.

This is the stl download link.

First make a circle in 03 inches.

Then make two slices that are 30 degrees apart. By making them 30 degrees you have to use the dimension tool

Then on one slice make a design for the snowflake.Once you're done with that you have to use the mirror tool to mirror it to the other side.

Then use the circular pattern tool and highlight the whole circle. Once you did that change 3x and to 6x and hit the check. 

Then Once you are done with the sketch, use the extrude tool And extrude the snowflake.  also put the depth to 0.125.

Then make a circle near the edge using the circle tool that is 0.2 inches. And make it 0.3 inches away from the edge using the dimension tool.

Then hit the check mark for the sketch in the used extrude tool  and extrude the circle. When you are extruding the circle make sure it is on solid and remove, and instead of blind quick it and put  through all.

Then you have to 3D print it.