Headphone/Ear Bud Bracelet

The sequel to the charger cord bracelet.

Supplies:

• a small bracelet buckle
• dead headphones/ear buds
• glue

Step 1:

Cut the ends off the headphones. Carefully cut off the small piece holding the wires together. Separate/pull the wires apart.

Put the wires through one side of the buckle. It should be long enough to go around your wrist + about 2".

The two shorter wires should be in the middle with the longer wires on the outside.

Cobra Knot:

1. Put one of the outside wires under both shorter/middle wires and on top of the other outside/second wire.
2. Put the second outside wire over both shorter/middle wires and under/through the loop of the first outside wire.
3. Tighten the knot.
4. Repeat steps 1-3 starting with the other side.

The colored wires from the charger cord might make it easier to figure out.

Keep tying knots until it is almost the correct length. Put the shorter/middle cords through the other side of the buckle. Fold the wires back and tie knots over them. When the bracelet is the correct length, cut and glue the ends.