Hands Free Music Page Turner
by CraigSteinfort in Workshop > Woodworking
709 Views, 5 Favorites, 0 Comments
Hands Free Music Page Turner
Hi I’m Keira. I am 9 in fourth grade. I was thinking of ideas and I thought of a page turner. Then, I thought of my brother who plays band, I thought, we could make a page turner for music books! That’s how I though of this idea! My dad screwed the screws in, helped me measure it and publish it. I did the rest!
Supplies
1- 5 ft 2x3
2- 2 ft 2x3
1- 1 ft 2x3
1- 16 in 2x3
20.5x16 in ⅜ thick plywood
7- 2.5x16 3-8 thick plywood
2 ft long small piano hinge with screws
Spool of string
Paperclips
1 in screws
2 inch screws
2- 2 ft 2x3
1- 1 ft 2x3
1- 16 in 2x3
20.5x16 in ⅜ thick plywood
7- 2.5x16 3-8 thick plywood
2 ft long small piano hinge with screws
Spool of string
Paperclips
1 in screws
2 inch screws
Make 7 Half Inch Holes in the 1ft Piece
Take the 2 Ft Pieces and Screw on the 20.5x16 Piece With 1 Inch Screw in Each Corner, Leaving 3.5 Inches on One Side.
Make ⅜ Inch Holes at the Top of the 2.5x16 Pieces.
Screw on the 1 Ft Piece to the Top of the 5 Ft Piece With a 2 Inch Screw
Screw on the 5 Ft Part on the Edge of the 2 Ft Piece With 2 Inch Screw.
Take the 16 in Part and on the Ends Cut a 45 Degree Angle. Screw It on Attached to the 5 Ft and 2 Ft Pieces With a 2 in Screw.
Cut the Hinges With a Metal Cutter So It Is 2.5 Inch 7 Pieces.
Drill Holes in the Hinges So It Looks Like the Pic Below.
Screw All the 2.5x16 Pieces and the Hinges on With Screws to the 20.5x16 Piece.
Screw 1 in Screw Lining Up With the 2.5x16 Pieces, Don’t Screw the Screws in All the Way!
Tie String Long Enough So It Stays, Repeat for All 7, These Are Your Pedals!
Tie String in the Holes of the 2.5x16 Long Enough to Reach the Pages, Through the Holes at the Top. Tie the String to Paper Clips.
Testing
How it works!