Half Life Crowbar Prop

Today I'm going to show you the steps that you need to go though to make your own crow bar from half life.

The one I have needed a lot of love. I found it on the side of the road when out on a walk. they just scraped the ditches the week before so this was a good find. you can chose any size that you want I deiced to chose a smaller size so I could carry it around easily. I most likely will make a resin cast but that's if want to take it to a con.

The next step that you need to do it to get a light coat of primer on the crowbar.and get it ready to paint a two tone paint job ready to crush some head crabs.

you are going to need two colors, metallic silver, and red orange. to do this easy you are going to want to put your silver on first and then mask off both ends to paint the middle orange.

Now all you have to do it just let dry and then you have it done. now its time to go bash some head crabs. I'm going to have some beauty shots later in the week up on my blog so check them out.