HOW TO CREATE a 3D BUS USING 3D MODELING SOFTWARE

In this tutorial article, we are going to 3D design a bus. The 3D modeling software that we are using is SelfCAD. The tools of SelfCAD that we will utilise are the 3D Shapes, Vertex Selection, Polygon Selection, Move Tool, Fillet Tool, etc. We will begin by 3D designing a cube and developing it.

You can also visit our page to check more articles such as how to design the 3D lower part of a body.

So, let's start with the steps!

First, go to 3D shapes and insert a cube to the working interface. Set width to 122, height to 126, depth to 585, width segment to 4, height segment to 2, depth segment to 2 and position y to 50. Then change to mesh+wireframe option.

Next, opt for vertex selection and select the corner most lower vertices of the object. Then use the move tool and move them along with the y-axis in about 70 values. After that, select all the vertices of the middle edge and move it along the z axis to -188 using highlighted gizmo.

Now, select all the vertices of the middle edges of the smaller face and move it along the z axis to 309.5 using highlighted gizmo. Then  select all the vertices of the middle edge of the same face and move it along the z axis to 319.5 using highlighted gizmo. After that, repeat the same step with the other face.

Next, select all the vertices of the left corner edge of the top face and move it along the z axis to 279 using highlighted gizmo. Then repeat the same step with the vertices of the middle edge but this time set y to 97.

Now, opt for edge selection and select all the corner edges of the object except for the bottom face. Then go to modify and select the fillet tool. Set the intensity to 4 and level to 3.

Next, we will select the edit details tool and click on the loop findings. Then add six vertical edges to the object. After that, opt for vertical selection and select the bottom face of the object.

Now, select the inset tool and set the amount to 16.87. Then select the extrusion tool and set the amount to -4.

Next, select the top faces of the smaller side and inset it to an amount of 4. Repeat the same step with the other side but this time set the value to 13.87. Then from the right panel opt for cube selection. Set top to 98.

Now, select four faces on each side of the longer face as shown in the image and inset it to an amount of 5. Then select consecutive top and bottom faces of three divisions as shown in the image and inset it to an amount of 7.

Next, go to 3D shapes and insert a cylinder. Set top radius to 29, bottom radius to 30, height to 30, position x to 55, y to 29 and z to 185, and rotation z to 90. Then select the circular face and inset it to an amount of 10.

Now, copy this object and move it along the z axis to -107 using highlighted gizmo. Then select mesh_8(1) and mirror it creating copies. Set the direction to the left and offset to 40.

We have 3D designed the bus utilising various parts and tools of SelfCAD. You can utilise an indistinguishable method to 3D design other 3D models of your choice.