Grenade Paracord Holder

Description

PDF

A simple easy print, this grenade model is highly detailed and is a functional tool to hold paracord.

Great for attaching to a backpack also.

Enjoy.

What you need:

1. 3D printer (obviously)
2. Paracord
3. Keyring
4. Superglue
5. Flush Cutters (optional)

Print the following parts in the orientation shown:

Grenade Body No Hexagons 1x

Grenade Top No Hexagons 1x

Grenade Spoon 1x

Grenade Pin 1x

Grenade Pin2 1x

Some Parts will require a small amount of support.

If your printer is tuned well, the support should come off easily. If not, a pair of snips is always handy.

Attach a keyring to the pin with a hole in it.

Apply a small amount of super glue to the top of the post shown, then place the top piece on top until the glue dries.

Thread one end of your paracord through either of the holes in the post shown, then start winding to your liking.

you may need to cut your paracord to size. Make sure to leave a little extra to tie off later.

Take the end of the paracord and tuck it in the loop just below it. Pull it tight and push the extra bit in between the other paracord loops as shown.

Place the spoon on the top of the grenade and secure it with the second pin. This is what will allow it to pivot.

Next place the remaining pin through its hole as shown.

Enjoy your new paracord grenade!