Glass Fuse Cabinet Pulls

by DaveInda in Workshop > Home Improvement

3126 Views, 59 Favorites, 0 Comments

Glass Fuse Cabinet Pulls

16679982638_16e6d57cf6_o.jpg
16245240424_8cab1a1770_o.jpg

Glass fuses are common, especially in older homes and appliances and periodically, they burn out. So, what to do with burned out fuses? One could throw them out, but, don't they kind of look like those expensive glass knobs for cabinets? Why not give them a second life?

What you need:

Glass fuses, one per door

Forstner drill bit the size of the fuse base (mine was 1/2 inch)

A pan-head screw long enough to go through the cabinet door, one per door

A drill bit the size of the screw's diameter (mine was 1/8 inch)

A sharp knife or chisel

A drill and a screwdriver

Preparing the Door

16841746396_d3580416a9_o.jpg
16867647135_ea91bc5e3a_o.jpg
16247696633_1d54da41d8_o.jpg
16681571819_e3ee457932_o.jpg

*Note: these photos are a dramatization: no photos were taken during the original build

Using the Forstner bit, drill a hole deep enough into the cabinet to hide the black base.

In the center of the larger hole, drill a pilot hole through the door for the screw.

Push the fuse into the hole hard enough so the ribs on this base mark the edge of the hole.

Use a sharp knife or chisel to cut small notches so the ribs can fit into the hole.

Attach the Pull

16867650475_f8eef9d99b_o.jpg
16245332574_e3454796e9_k.jpg
16867772325_c5e9753711_o.jpg

Use a nail to punch a pilot hole into the center of the rear of the fuse - this is where the screw will attach to the fuse.

Push the fuse firmly into the hole in the door.

Insert the screw from the rear and screw in until tight.

Enjoy your new glass pulls!