Fusion 360 Phone Stand

I needed a phone stand yet my phone battery was depleting and I constantly needed it plugged in. I searched and searched but my own skills were looking like my best option to get the stand I needed.

I wanted to find a phone stand I could use that both was able to charge and able to project audio. With no luck I decided that I needed to make my own to meet all my wants.

After figuring out what I wanted the stand to included I needed to get the proper measurements. I needed to measure all the dimensions of the phone so it would fit on the stand properly. Then I needed to measure the speaker and charger port. This allowed me to make proper sized holes to fit a charger and allow audio to flow.

After acquiring all the necessary measurements I booted up Fusion 360. I then created my design that included the charger hole and speaker paths. This design finally hit all my wants and needs from a phone stand.

With a finished design I rendered up the stand and began to prepare it for manufacturing.