Foam Board Volcano

by Herex1 in Circuits > Electronics

248 Views, 1 Favorites, 0 Comments

Foam Board Volcano

IMG_20210820_222028_3.jpg
Be advised that I am using the best supply available to me you may have better supplies depending on where you are from

Supplies

(1)foam board (pink foam most preferred)
(2)knife
(3)wire
(4)red tape (transparent)
(5)light (red or orange light most preferred)
(6)paint(red,black or brown) and brush
(7) batteries
(8)glue or sticks

Cut Foam Board Into Shapes

IMG_20210817_171942_0.jpg
tmp-cam-891778231756891555.jpg
tmp-cam-1239407004332955011.jpg
The shapes should resemble that of mountain ..for ease I cut 3 circle of different diameter and cut terrain in them

Cut Hole Into Foam Board

tmp-cam-4030319641457354939.jpg
Cut through holes through two of the circle foam board and cut away parts of the third such that it looks like a plate

Paint

tmp-cam-4813029181137584683.jpg
I used a black paint here

Fit Light Into the Plate Board

IMG_20210820_224947_6.jpg

Cover the Plate Foam Inner With Red Tape

IMG_20210820_224856_2.jpg

Select Another Foam Part and Poke Light Covered in Red Tape Through It

IMG_20210820_225134_4.jpg
IMG_20210820_225259_6.jpg

Set the Pcs of Foam Board One Over Another and Join the Wire Connected to the Light in Series

tmp-cam-4294807859948978808.jpg

Connect the Wires to the Battery and Light It Up

IMG_20210820_223201_2.jpg

Hold Down the Layers of Foam With Either Glue(do Not Use Super Glue) or Just Poke Long Sticks Through It

IMG_20210820_223416_2.jpg
IMG_20210820_223452_8.jpg
IMG_20210820_223543_6.jpg