FloorKnob - Hands Free Doorknob

by BrazenRain in Craft > Cardboard

2257 Views, 32 Favorites, 0 Comments

FloorKnob - Hands Free Doorknob

floorknob.jpg
floorknob1.jpg

A home-made FloorKnob will allow you to open most doors hands-free. This simple design is made of common household materials and can be non-destructively mounted to almost any doorknob or door handle.

To make one, you will need:

14" x 11" sheet of cardboard.

6' thin, strong cord (5/32" diameter paracord used in instructions)

3M poster hanging command strip

Tape

Required Tools:

Marker

Scissors

Box cutter or crafting blade

Lighter (for cord if applicable)

Cardboard

step1.PNG
step1.PNG

Cut out a 14”x11” piece of cardboard.
If necessary, align pre-existing folds in the cardboard with the folds to be made.

Cardboard

step2.PNG

Cut along dash-dot lines, discarding corners.

Cardboard

step3.PNG

Fold Flap B underneath, creasing along the dashed line. Use a sharp tool to score the cardboard without cutting through to guide the fold if necessary.

Cardboard

step4.PNG

Fold Flaps D and E inward along dotted lines and unfold.

Cardboard

step5.PNG

Reinforce the indicated regions of Flap A with tape, folding the tape around the edges to cover both sides.

Cardboard

step6.PNG

Fold Flaps C and D downward along dotted line, scoring the cardboard as necessary.

Cardboard

step7.PNG

Lift cardboard and refold Flaps D and E to meet Flap B. Punch two holes approximately 1” inward in each direction from the corners of Flap C.

Cord

step8.PNG
IMG_0453.jpeg

Thread cord through the back of one hole, then under Flap A and through the front of the other hole. Tie a knot to secure. Tape joints and loose flaps securely.

Cord Guide

IMG_0454.jpeg

Assemble and tape a cord guide if desired. This will keep the foot piece from swinging or getting between the door and the door frame. Attach it to the door with a command strip at roughly a foot above the ground. It may be advisable to mount this after the final height above the floor is chosen.

Doorknob Attachment

548a0f20d535cfdf1e000022.jpeg
548a0f76d535cf3f8a00006b.jpeg
548a0fcad535cfa45600001c.jpeg
548a0ffed535cf3f8a00006c.jpeg
548a1038d535cf396200002d.jpeg

Use scissors to cut a 3M poster command strip in half lengthwise. Attach the "wall side" adhesive to the top of the doorknob shaft. Expose the "poster side" adhesive and lay a section of cord on top. Wrap the cord tightly around the shaft at least five times such that the cord hangs off of the side not facing the door frame. Leave about six inches between the foot attachment and the floor.

Complete!

IMG_0457.jpeg
IMG_0450.jpeg
IMG_0456.jpeg

Hands-free Open Door Policy!