Flip Top Lego Table

by varmitwife in Living > LEGO & K'NEX

6514 Views, 74 Favorites, 0 Comments

Flip Top Lego Table

IMG_0687.JPG
IMG_0620.JPG

This table was designed and built for my 2 year old grandson. The top is stained and sealed and is reversible. One side for lego blocks and the other for multi-use. The ends are small shelving units to store Legos, etc.

Material List, But With Improvisations...

4'x8' sheet of 3/4 inch plywood

2'x4' sheet of 1/2 inch plywood

4 1x2 pine boards 8'

1 1x3 pine board 6'

6 lego base plates

Wood glue

Contact Adhesive

Sandpaper

Nail gun w/nails

Router

Cut List

IMG_0374.JPG

4 (plywood) 18" long x 8" wide for vertical base pieces

4 (plywood) 22 1/2" long x 6 1/2" wide shelves

2 (plywood) 22 1/2" long x 2 1/2 wide top base supports

2 1x3 boards 31 3/4" long front and back stretchers

8 1x2 boards 22 1/2" long shelf trim

2 1x2 boards 49 1/2" long table top trim, measure and cut to size

2 1x2 boards 25 1/2" long table top trim, measure and cut to size

End Support/shelving

IMG_0377.JPG
IMG_0378.JPG
IMG_0386.JPG

Glue and use nail gun to secure shelving ends and trim.

Attaching the Front and Back Stretchers

IMG_0398.JPG
IMG_0400.JPG

I used metal bracing for extra support.

Sizing the Top

IMG_0407.JPG
IMG_0512.JPG

Make sure to leave top a little larger so it's not too tight when removing to flip over.

Trimming the Top

IMG_0515.JPG
IMG_0516.JPG
IMG_0534.JPG

Trim the top by gluing, then using nail gun to secure. Make sure that the lip on the top and bottom will be equal. Router the edge a bit so it's not such a sharp edge.

Adding a Little Trim

IMG_0539.JPG
IMG_0541.JPG
IMG_0542.JPG

I added a little trim to dress it up a bit. Nothing fancy, just used ripped boards.

Stain or Paint

IMG_0544.JPG
IMG_0545.JPG

I chose to stain the bottom part of the table gray.

Stain or Paint the Top

IMG_0604.JPG
IMG_0614.JPG

I chose to stain the top and seal it will poly acrylic. Be sure to do both sides of the top.

Adding Lego Base Plates

IMG_0630.JPG
IMG_0661.JPG

Measure to center plates like you'd like them. tape off and carefully spray adhesive. I used contact adhesive to stick on the Lego base plates. Spray both the table top and the back side of the base plates.

Finished Product

IMG_0621.JPG
IMG_0622.JPG
IMG_0687.JPG

This table should bring years of fun and activity to my 2 year old grandson.

Addendum to Original

natural wood table1.jpg
natural wood table2.jpg

I had enough material, minus the legs, to make another table. I purchased (2) 36 INCH 2"X2" and cut them into four 18" legs and glued them to bottom of table and nailing them with nail gun. Then I braced the ends with some scrap wood I had using my KREG jig. This table seems very sturdy. I plan to clear coat it with spray polyurethane. This table will stay at my residence for my 2 year old grandson, while the blue table went to his house.