Flaming K'nex Spinner (Of Death!)

This is a neat idea I had, where you light candle at both ends then spin it lightly so that as the candles melt separately they try to balance by spinning.

Made out of k'nex!

You need;
Tin foil,
a tall candle,
a lighter,
a long, thin, straight nail,
a knife,
a cutting board,

and
4 gray k'nex pieces
2 Red quarters,
32 purple quarter-spheres,
4 half-moons,
16 half-sphere,
2 circles,

6 short green rods,
45 short white rods,
30 blue rods,
4 yellow rods,
12 orange rods (with the little separation at each end, though normal red rods would work).

Build two of these, the photos should be clear enough.

Once you've built both sides, add these nine rods onto one then connect them together like so.

Spread some tin foil on the base so that when the wax drips it won't get all over your floor/table!

If the wick is not exposed on both sides of the candle, cut off one end and sharpen it so that the wick is usable.

Then, put a nail through the middle. Be careful that it is straight and try not to break the candle.

Light one end whilst holding the other, then light the other end.
You may have to hold it flat for a while so they really get burning...
After about sixty seconds, spin lightly