FinalExam

by PackJC in Circuits > Arduino

186 Views, 1 Favorites, 0 Comments

FinalExam

4.png

Connect the 5V and the GND to the breadboard. Be sure to not get this mixed up, and make sure they are properly connected.

Connecting the TFT Screen

3.png

Connect the TFT screen.

VIN connects to the 5V rail on the breadboard

GND connects to the GND rail on the breadboard

SCK connects to pin 13

SI connects to pin 11

TCS connects to pin 10

RST connects to pin 9

CCS connects to pin 8

Connect Color Changer Button

2.png

This button changes the color of the lines when pressed, it's a random color each time.

Place the button on the breadboard. Follow the diagram above very closely. The bottom left of the button connects to the 5V rail. The bottom right connects to a 220-Ohm resistor then to the GND rail on the breadboard. The pin above the one with the resistor connects to pin 12.

There you go!

Connecting Both Potentiometers

1.png

Place two potentiometers on the breadboard. Connect the double ended sides of both to the 5V and GND respectfully. Follow the diagram. The pin opposite of these, one goes to A1 and the other goes to A2.

The pot connecting to A1 is for the first line.

The pot connecting to A2 is for the second line.

Finished!

6.png

If any issues arise be sure to follow all of the diagrams very carefully. Everything will work correctly!

Thanks!