Filament Holders

Hi there, thanks for viewing my instructable.

Before these clamps our filament rolls we're laying on the wooden boards. So if you needed the bottom one you would topple the whole thing. I decided to make a simple and efficient solution for this.

!!!!DISCLAIMER: IF YOU WANT TO TAKE PROPER CARE OF YOUR 3D PRINTER. KEEP THE FILAMENT IN A DUST FREE ENVIRONMENT, TOO MUCH DUST AND DEBRIS ON THE FILAMENTS WILL EVENTUALLY CLOG YOUR NOZZLE!!!!

I made some notes on the drawing, check them out!

......

Export your own .SVG drawing as a .DFX file to send it to your milling machine.

I milled all my T pieces in two steps;

1. Mill everything at a low speed (35mm/s) and don't go deeper than 1 or 1.5 mm, this causes the least outbreak.

2. Mill everything at a higher speed (85-100mm/s)

Sand the edges and remove any tabs.

Thanks for viewing my instructable.

:)