Figure 8 Knot With Loop/Bight

by matt392 in Outside > Knots

5190 Views, 103 Favorites, 0 Comments

Figure 8 Knot With Loop/Bight

564a988f45bceb37cc000bb3.jpeg
564a8eb350e1b6e724000f27.jpeg
How to create a Figure 8 knot with a loop (bight). There are a number of guides and videos on Instructables and the web, but they were all fairly difficult to follow. This Instructable is designed to break the process into smaller steps and to make it easier to follow visually.
Parts:
1. Paracord
2. Duct tape
3. Black marker (to darken part of the paracord to make it easier to follow the looping process)


Loop Paracord

564a938e15be4dd15a00055a.jpeg


1. Use the marker to darken about 10 inches of the paracord.
2. Create loop in the paracord with the loop on the right.
3. Round the loop at the point where the black and orange meet.


Duct Tape Ends

564a9424937ddbb6040010eb.jpeg
  1. Duct tape the loop end on the right.
  2. Duct tape the loose end (black paracord) to the orange paracord.
  3. The duct tape is designed to make it easier to see the looping process.

Loop End

564a95e850e1b6e724000f6d.jpeg
  1. Loop end of paracord to left over the other piece of duct tape.

Pass Under Paracord

564a96bd2e7fb62b200007a2.jpeg
  1. Pass the end of the paracord under the 2nd piece of duct tape.
  2. The end of the paracord should be on your left side.

Pass Through Loop

564a97574fbadebd3e000e70.jpeg
564a97e845bceb03030005b0.jpeg
  1. Take the end of the paracord and start to push it through the loop.
  2. Start to tighten the knot.

Pull Tight

564a988467400cbfb7000674.jpeg
564a988f45bceb37cc000bb3.jpeg
  1. Pull the knot tight.
  2. Remove the duct tape from the loop.