Fiat Ducato Citroen Relay Peugeot Boxer Cup Holder Installation Guide

The Fault

Poor design cup holder from factory causing spilt drinks.

Peugeot Boxer, Citroen Relay and Fiat Ducato do not come with an appropriate size and depth cup holder unless selected at factory where it was molded into the design of the glovebox.

The other cup holders in the centre console and door pockets are poorly designed. They are not deep enough causing drinks to fall out, and they are out of reach of the driving position.

Other solutions involve drilling and screwing into the centre console which is costly should it go wrong.

The Solution

The X8R cup holder is a direct fit and can be installed in under 5 minutes

Our cup holder system is designed to fit perfectly in the mechanism of the glovebox. It does not involve any drilling or additional screws. Simply loosen the original screws within the glovebox, slide in our cup holder system and tighten the screws. The glovebox can still be used as originally designed and you will have no more spilt drinks!

The double cup holder features flexi prongs which securely hold any drink up to 70mm in diameter including standard size cans, small and large disposable coffee cups, bottles drinks etc.

The cup holder bracket is made from precision engineered stainless steel and will not break like cheap imitation.

Vehicles Affected

Peugeot Boxer 2007 onwards

Citroen Relay 2007 onwards

Fiat Ducato 2007 onwards

Associated part numbers:

16 070 885 80, 16 079 396 80,  

It is suitable for left and right-hand drive models.

You Will Receive

1 x Double cup holder

1 x Stainless steel cup holder bracket

You will need:

T20 torx bit with rachet

Open the glovebox.

Loose the two screws at the top of the glovebox using a T20 torx bit on a rachet. Do not remove them completely, a few turns will be enough.

Slide the cup holder bracket to sit on the loosened threads of the screws.

Hold the cup holder in place with one hand whilst tightening the screws with the other.

This is the installation complete.

This completes the installation. If you need any further guidance on this install or would like to purchase the parts shown please call us on +44 01843 446643 or email us at sales@x8r.co.uk. Please also check out our instruction guide on YouTube. www.x8r.co.uk Installation is carried out at installers risk, if unsure please contact us or a professional, X8R Ltd cannot be held responsible for any adverse result of installing this product or any injuries caused by install, if in doubt ask a professional. All images and texts are copyright X8R Ltd 2024.