Fan Boat Lego DIY

This is an instruction for building a beginner level fan boat using basic legos.

Locate the flat 2x10 (red) block, and the 45 degree block (yellow) block. Then attach the yellow block at one end of the red block as pictured below.

Find the 2x8x1 (white) block. Attach it directly behind the yellow block. There should be one row of connector dots left on the red block. See picture below.

Locate the flat 4x10 (grey) block and attach it atop the white & yellow blocks. Make sure it is centered on the white & yellow blocks.

Holding the bottom red block by the two remaining cennector dots. Attach the clear 45 degree block to the upper left corner. 

Hold as in Step 4. Attach the yellow roll-bar to the second row of the 4x10 (grey) block up from where your fingers are located.

Clip fan blade (black) to the 1x2 (white) block with the cylindrical pop-connector. 

Attach fan assembly to the boat direct to the rear of the roll bar. Make sure it is centered on the 4x10 (grey) block.

Enjoy your completed Fan Boat!