Face Shield

These are the instructions to assemble the face shields. All that you need is a stapler and scissors

If you have any questions, contact me at 914-844-7905 or jasonslaveneder@gmail.com

Peel plastic film from both sides of plastic sheet.

Trim plastic sheet, according to picture above.

Peel adhesive backing from foam.

Make sure that the adhesive backing comes off of the ovals, as you will have to peel those separately.

Note: While pictures may have oval cutouts removed from foam, it is recommended to leave those in place!

Stick foam along the side with the uncut corners. Try to center it as best as possible.

Use picture above as guide.

Line elastic up with foam, with the loose end going away from the shield. Place the end that will be stapled approx 1/4 inch away from foam strip.

Place 2 horizontal staples, and 1 vertical. Use pictures above as guide.

Take loose end, and staple the same way as you did for the first end.

This part is a little tricky, so make sure that the elastic looks the same as it does in the pictures above.