External LED Blinking

In this tutorial, we will learn how to set up and use the STM32 Black Pill Blinking an External LED using HAL Programming.

Following are the supplies required for this task-:

• STM32 Black Pill development board (STM32F103C8T6)
• External LED
• Resistor (optional, depending on the LED)
• Jumper wires
• STM32CubeIDE installed on your computer
• USB cable

• Enter a project name and choose a location to save your project.
• Select the appropriate toolchain (e.g., Ac6 STM32 MCU GCC) and click "Next."
• Configure the project settings such as HAL, CMSIS, and middleware. For this tutorial, we will leave the default settings.
• Click "Finish" to create the project.

1. Connect the anode (+) of the external LED to the configured GPIO pin on the Black Pill board.
2. Connect the cathode (-) of the LED to ground (GND) on the Black Pill board.
3. Optionally, insert a resistor between the GPIO pin and the LED to limit the current if necessary.

Include the necessary HAL Libraries at the top of the file

following is the code-:

int main(void)

{

HAL_Init();

SystemClock_Config();

// Initialize GPIO pin for external LED

GPIO_InitTypeDef GPIO_InitStruct;

__HAL_RCC_GPIOA_CLK_ENABLE(); // Change GPIOA to appropriate port

GPIO_InitStruct.Pin = GPIO_PIN_5; // Change GPIO_PIN_5 to appropriate pin

GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;

GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_LOW;

HAL_GPIO_Init(GPIOA, &GPIO_InitStruct); // Change GPIOA to appropriate port

// Main loop

while (1)

{

// Toggle LED state

HAL_GPIO_TogglePin(GPIOA, GPIO_PIN_5); // Change GPIOA and GPIO_PIN_5 to appropriate port and pin

// Delay

HAL_Delay(1000);

}

}

• Power on the STM32 Black Pill board.
• The LED should start blinking at a 1-second interval.

Conclusion:- The STM32 Black Pill is successfully set up and programmed to blink the external LED using HAL Programming.