Experiment: LCD 16x2, PIP-BOY

Hi guys!

So, this is my experiment using a I2C 16x2 LCD screen. This experiment is based on the Bethesda game Fallout 4's PIP-BOY. This experiment will show some of the capabilities of the LCD 16x2 screen.

Listed below are the items you need:

- 1x Arduino UNO (or equivalent)

- 1x I2C SERIAL LCD 1602 MODULE

- 1x Breadboard

- 14x Breadboard jumper cable wires

- 4x Male to Female jumper cables

- 1x Potentiometer / trim resistor

- 2x Tactile switch / Push Button

- 2x Resistors 1.5k Ohm (This is what I have been experimenting with, you could try others)

Follow the diagram below to see how to connect the equipment!

Check out the files below for the raw code.

Thank you for taking the time trying this experiment! Hope you have enjoyed this!

Do not hesitate on submitting any suggestions to me to improve these Instructables.