EXTRA HANDS FOR SOLDERING - OCTOPUS
by chrisjlionel in Workshop > Tools
7955 Views, 265 Favorites, 0 Comments
EXTRA HANDS FOR SOLDERING - OCTOPUS
A extra hands (helping hand), also known as a third hand, is a type of extremely adjustable hands to hold materials near each other so that the user can work on them.
MATERIALS USED
- Piece of wooden block
- Wood sticks with square cross-section (10x10mm)
- Alligator clips - 4 pairs
- Flexible and stiff wire of preferable gauge
- 0.5 W LED - 2 nos
- SPST switch
- 9 V battery with snap
- Wires, Screws and other consumables.
- Tools - Fixtures, Cross-cut saw, Drill, Angle Grinder, pliers, Cutters, Screw Drivers.
Mark & Cut a Slot With Cross-cut SAW
- Use a wood marker or Mica cutter to make impression in wood.
- Then use Cross-cut saw to make a slot just enough for 4 wires to pass.
Insert Wires and Secure Them With Tacker-gun
Connect the Alligator Clips to the Free Ends
Solder Lead Dispenser
Mark and Cut three pieces as shown in the pictures
Drill N Screw
Make hole and then Screw as shown
Slide the Spool in and Screw It to the Wooden Block
Winding Over the Syringe
Screw and Chop Off Its Excess Using Angle Grinder With Cut-off Disc
0.5W LED's in Series
Finishing - Light
That's All!! Work With Caution!
Optional - De-soldering Wick Holder
Optional - Guide for Solder Wire Feed
Optional - Holding Fixtures
